GA C2.8 2.8

Should the inventor be designated in the request? 
2.8.001
It is recommended that the inventor always be identified (Box No. III, PCT request form), unless there are special reasons for not doing so. The name and address of the inventor must be furnished in the PCT request form if the applicant wants to enter the national phase of a state requiring that the data of the inventor be given in the request upon filing. The consequences of non-compliance are a matter of national law. For up-to-date information on the national law of each of the PCT contracting states, see the WIPO PCT Guide. 
WIPO PCT Guide 5.035-5.038 
PCT Newsletter 
8-9/2013, 8 
2.8.002
In so far as the applicant aims to obtain a European patent, the data concerning the inventor – if not already submitted during the international phase – must be provided upon entry into the European phase (see points 5.2.006 and 5.12.001 ff).

10 references found.

Click X to load a reference inside the current page, click on the title to open in a new page.

EPC Implementing Rules

EPO Guidelines - E General Procedural Matters

EPO Guide for Applicants, part II Int.

EPO Guide for Applicants, part II Int. - C The EPO as ISA and SISA

PCT Articles

PCT Implementing Rules